The Essential Project Forum

Hello,

on a standalone Windows installation we tried to change the memory settings in the Protege.lax like described here: http://www.enterprise-architecture.org/blogs/

After leaving the Preference dialog (and restarting Protege) the value is reset to the default.

We also tried starting the application as administrator without any different result. Do you have any ideas what might caus this behavior?

Thanks and regards,
Thomas

Apologies for the delay....

Do you have write permissions to the Protege install folder?

It's possible that in some corporate environments, write permissions are restricted to the "Program Files" folder where Protege is installed.

Locate the Protege folder in the Program Files folder and right click and choose Properties. Go to the Security tab and see if you're allowed to write to that folder.

Let me know how you get on

Thanks

Neil

Hi,

I would also check that 'if' you copied and pasted the value you didn't leave a space before or after, that seems to annoy protege. I fond it easier to edit the protege.properties file.

Colin